Shop: Dynafit TLT Speed/Speedfit

DOWNLOAD Speed/Speedfit User Guide

Touring:

• Rotate the heel unit 180 degrees so that rear pins face backward
• Open toe unit jaws by pressing down on toe lever
• Align boot pin holes with front pins, step down
• Lock the toe by pulling up on the toe lever all the way up through ratcheting clicks 
• Flip two heel risers forward as need for added climbing height

Skiing:

• Rotate heel unit 180 degrees so that rear pins face forward
• Align boot pin holes with front pins, step down. Toe lever remains in first position
• Step down to engage rear pins
• Press down on toe lever with ski pole to exit binding

Adjustment:

• Boot sole adjustment of 1cm, use Torx 20 bit in lowest rear screw. Lefty tighty for Dynafit
• Ensure it is adjusted with a 4mm gap on the pins between the rear of the boot and the heel unit
• Lateral release value is adjustable using Torx 20 bit on higher rear screw
• Forward release is fixed at roughly either 7 or 9 (Speedfit or Speed version bindings respectively)

Binding specifics:

• The Speed and Speedfit have optional brakes which screw on the base of the heel unit
• Leash can be girth hitched to leash loop which is mounted under the toe piece
• Snow and ice buildup is possible under the toe springs if the bindings are open and skis are on a backpack after touring in wetter snow. Clear this area with ski pole tip and open and closing. Lock then unlock to check if binding is fully clamping the boot.
• If heel unit is removed from the track, spin the worm drive into the most open position before putting it back on the track